0
RESEARCH PAPERS

Hydrodynamic Lubrication of the Rib-Roller End Contact of a Tapered Roller Bearing

[+] Author and Article Information
Nabil Gadallah, Gerard Dalmaz

Laboratoire de Mecanique Des Contacts, ERA C.N.R.S. 665, Insa de Lyon, 69621 Villeurbanne, France

J. Tribol 106(2), 265-272 (Apr 01, 1984) (8 pages) doi:10.1115/1.3260898 History: Received February 24, 1983; Online October 29, 2009

Abstract

The behavior of the lubricated rib-roller end contact of a tapered roller bearing is studied both theoretically and experimentally. A theoretical hydrodynamic approach was first developed for smooth and rigid surfaces for the particular geometry and kinematic conditions found in this contact. Simultaneous measurements of traction forces and film thicknesses by optical interferometry are performed in a special device made of a flat glass disk and a steel toric specimen which simulates this contact, lubricated with a mineral oil at ambient temperature. Good argeement is noted for both film thickness and traction forces between the hydrodynamic theoretical and experimental results. The experiments which are extended to the elasto-hydrodynamic regime show that central and minimum film thicknesses are lower than the calculated values using classical fully flooded and starved elastohydrodynamic theories. This departure is attributed to side flow effects. Traction curves obtained in this regime, under moderate pressures, show that the oil behavior remains newtonian.

Copyright © 1984 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In