0
RESEARCH PAPERS

A New Method of Evaluating Metal-Working Lubricants

[+] Author and Article Information
T. C. Ramaraj, M. C. Shaw

Arizona State University, Tempe, Ariz. 85287

J. Tribol 107(2), 216-219 (Apr 01, 1985) (4 pages) doi:10.1115/1.3261023 History: Received February 06, 1984; Online October 29, 2009

Abstract

When two identical penny shaped disks mounted one above the other are upset simultaneously in uniaxial compression, they deform differently if friction on the upper die surface may be covered by a thin film of teflon which results in essentially zero friction there while the lower die surface corresponds to a lubricant-die material-work material combination to be evaluated. After deformation, the thickness of the upper disk at its center (h1 ) will be less than the central thickness of the lower disk (h2 ) if friction on the lower die surface is greater than on the upper die surface. The ratio h1 /h2 provides a sensitive measure of the difference in frictional resistance on the upper and lower die surfaces and may be used to evaluate different lubricant-die material-work material-die finish combinations for different degrees of reduction. Representative experimental results are presented and discussed.

Copyright © 1985 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In