0
RESEARCH PAPERS

The Tribological Behavior of TiN Coatings Prepared by IBAD

[+] Author and Article Information
S. A. Dillich, R. A. Kant, B. D. Sartwell, J. A. Sprague, F. A. Smidt

U.S. Naval Research Laboratory, Washington, D.C. 20375-5000

J. Tribol 113(1), 214-219 (Jan 01, 1991) (6 pages) doi:10.1115/1.2920592 History: Received February 15, 1990; Revised July 06, 1990; Online June 05, 2008

Abstract

Ion Beam Assisted Deposition (IBAD) provides the ability to control the micro-structure, and therefore the properties of thin films and coatings. This paper describes the tribological properties of TiN coatings prepared by reactive IBAD using evaporation of Ti from an electron beam evaporator in a 10−3 to 10−4 Pa partial pressure of nitrogen and simultaneous bombardment with a directed beam of 0.5 keV Ar+ ions. Films prepared with an Ar+ to Ti atom arrival rate ratio of 0.1 were found to be soft (Knoop hardness of < 1000 with 5 gr load) while those prepared at an arrival rate ratio of 0.4 were hard (Knoop hardness of ~2000 at 5 gr load). Transmission electron microscopy of the films showed the soft films had significant porosity at the grain boundaries while the hard films had almost none. All films were highly adherent. The wear life during pin on disk testing was a complex function of film hardness, ductility and debris formation.

Copyright © 1991 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In