0
RESEARCH PAPERS

Elastohydrodynamic Lubrication at Impact Loading

[+] Author and Article Information
Roland Larsson, Erik Höglund

Division of Machine Elements, Luleå University of Technology, S-971 87 Luleå, Sweden

J. Tribol 116(4), 770-776 (Oct 01, 1994) (7 pages) doi:10.1115/1.2927331 History: Received March 01, 1994; Revised June 13, 1994; Online June 05, 2008

Abstract

Experimental and theoretical studies of elastohydrodynamically lubricated contacts normally assume static or quasi-static conditions. Nonsteady conditions are, however, very common, e.g., in machine elements such as ball bearings, gears, and cam-follower mechanisms. In this paper, the case of a ball impacting a flat lubricated surface is investigated theoretically. This case implies transient conditions and the lubricating effect is due to pure squeeze action in the contact. Pressure and film thickness distributions are computed during impact and rebound. The results of the analysis show the effects of ball mass, initial impact velocity, lubricant properties, and the thickness of the applied lubricant layer on, for example, minimum film thickness, maximum impact force, and maximum pressure. Increasing impact velocity increases the minimum value of film thickness achieved during the total impact time. The damping capacity of the lubricating film is very high at low impact velocity and small ball mass. In fact, the damping is so high that no rebound occurs if the velocity or the ball mass are smaller than certain critical values. The thickness of the lubricant layer has very little influence on the results if it is thicker than a certain value. If the pressure-viscosity coefficient is increased, the film becomes thicker.

Copyright © 1994 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In