0
RESEARCH PAPERS

Cutting Force Variation Due to Wear of Multi-Layer Ceramic Coated Tools

[+] Author and Article Information
S.-S. Cho, K. Komvopoulos

Department of Mechanical Engineering, University of California, Berkeley CA 94720

J. Tribol 120(1), 75-81 (Jan 01, 1998) (7 pages) doi:10.1115/1.2834193 History: Received August 26, 1996; Revised December 20, 1996; Online January 24, 2008

Abstract

Cutting forces were measured during turning AISI 4340 steel with uncoated, two-layer coated (TiC/Al2 O3 ), and three-layer coated (TiC/Al2 O3 /TiN) cemented WC-Co inserts possessing chip-breaker grooves in order to investigate the progression of tool wear. The variations of cutting force signals are interpreted in light of predominant wear mechanisms. A characteristic feature of wearing coated tools is shown to be the rapid increase of the radial and axial cutting forces when the tool life is reached. This behavior is associated with both the increase of the real contact area on the nose and the flank face due to coating delamination and the relatively less severe wear on the rake face. Normalizing the cutting forces by those of unworn tools yields a single curve for each cutting force. The instant at which either the radial or the axial force deviates from these curves determines the wear life of coated tools. The good agreement between results for the wear life of coated tools obtained from cutting force and nose wear measurements suggests that the wear life of multilayer ceramic coated tools can be accurately determined by monitoring the cutting force response.

Copyright © 1998 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In