Finite element analysis was used in the current study to examine the effects of strain hardening and initial yield strength of workpiece material on machining-induced residual stresses (RS). An arbitrary–Lagrangian–Eulerian finite element model was built to simulate orthogonal dry cutting with continuous chip formation, then a pure Lagrangian analysis was used to predict the induced RS. The current work was validated by comparing the predicted RS profiles in four workpiece materials to their corresponding experimental profiles obtained under similar cutting conditions. These materials were AISI H13 tool steel, AISI 316L stainless steel, AISI 52100 hardened steel, and AISI 4340 steel. The Johnson–Cook (J–C) constitutive equation was used to model the plastic behavior of the workpiece material. Different values were assigned to the J-C parameters representing the studied properties. Three values were assigned to each of the initial yield strength and strain hardening coefficient , and two values were assigned to the strain hardening exponent . Therefore, the full test matrix had 18 different materials, covering a wide range of commercial steels. The yield strength and strain hardening properties had opposite effects on RS, where higher and lower or decreased the tendency for surface tensile RS. Because of the opposite effects of and ( and ), maximum surface tensile RS was induced in the material with minimum and maximum and values. A physical explanation was provided for the effects of , , and on cutting temperatures, strains, and stresses, which was subsequently used to explain their effects on RS. Finally, the current results were used to predict the type of surface RS in different workpiece materials based on their , , and values.
Effects of Strain Hardening and Initial Yield Strength on Machining-Induced Residual Stresses
- Views Icon Views
- Share Icon Share
- Search Site
Nasr, M. N., Ng, E., and Elbestawi, M. A. (May 23, 2007). "Effects of Strain Hardening and Initial Yield Strength on Machining-Induced Residual Stresses." ASME. J. Eng. Mater. Technol. October 2007; 129(4): 567–579. https://doi.org/10.1115/1.2772338
Download citation file: